This is an awesome Cold Steel SRK made from a new old stock factory overrun blank. The blade is about 5.8 inches long. This particular blank does have the tang stamp whereas many of the USA overrun blanks do not. To make this knife, I first finished out the sanding and polishing of the blank.I then drilled and shaped the custom guard from cold worked. 188" X 0.75" brass flat bar. The beautiful figured desert ironwood (Olneya Tesota) handle was made by boring a slot just over the tang thickness and width; the wood handle is one piece. I drilled and milled a tang slot in a brass bar section and drilled a pilot hole for a tang pin. The slots in the guard and pommel are good slip fits. All pieces fit up flush and tight.
They were assembled first using high strength Devcon long setting epoxy. After curing, I shaped the handle, guard, and pommel. I then finish-drilled the pommel pin hole and drove a high strength rod pin full length.
The handle and pommel were shaped and then sanded to 3000 grit paper prior to applying multiple coats of Tru Oil to the handle. The blade was finished to 1500 grit paper. The shaped handle feels outstanding in the hand and looks great. The blade is full and extremely sharp! Total length of the knife is about 10.25 inches.The item in the pictures is what you will receive. Wait to pay until combined invoice is sent, and request one if needed. All items are guaranteed unless otherwise noted. The item "Cold Steel USA SRK Carbon Steel V Ironwood Sculpted Handle & Brass Hardware NEW" is in sale since Monday, August 30, 2021. This item is in the category "Collectibles\Knives, Swords & Blades\Collectible Fixed Blade Knives\Modern Fixed Blade\Factory Manufactured".
The seller is "22brrem788" and is located in Tremonton, Utah. This item can be shipped to United States.